Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Windows & Doors: The Miami Owner’s Guide
We install and service Wellborn-compatible windows and doors across Miami, and most single-unit replacements land between $5,310 and $17,700 installed, with impact-rated upgrades running $9,440 to $29,500. Most standard swaps are finished in a single visit; larger or impact-rated projects get a scheduled installation window because they require permit and inspection. Groundwork Construction Co. of Miami is an independent service provider, not affiliated with Wellborn.

Owners usually find the problem the same way: a window that won’t latch flush after a humid week, condensation trapped between panes that no amount of wiping fixes, or a sliding door that needs a shoulder to close. In Miami, salt air and hurricane-season pressure changes show up on Wellborn hardware and glazing seals faster than most product literature suggests. By the time a homeowner calls us, the symptoms have usually been there for a season or two.
Key Takeaways
- Installed Wellborn-compatible window replacement in Miami runs $5,310 to $17,700; impact-rated units $9,440 to $29,500.
- OEM vs. aftermarket matters most on hardware, weatherstripping, and glazing seals, not on the frame itself.
- Florida’s salt air and UV load shorten seal and finish life compared to inland markets.
- We don’t stock parts or carry them on a truck. We source the correct part for your model and quote it in writing before work starts.
- Every install is backed by our 730-Day Done Right Promise.
Which Wellborn Models This Applies To
Wellborn’s window and door lines show up in Miami homes in a few common configurations: single-hung and double-hung vinyl units, horizontal sliders, and sliding patio doors, plus fixed and casement windows on newer builds. The first job is identifying which line you actually have, because hardware and weatherstripping aren’t interchangeable across them. Check the etch or label on the lower corner of the glass, the manufacturer sticker inside the jamb, or the frame profile itself.
Measure before you buy anything. On a slider or single-hung, the critical dimensions are the rough opening and the glass width-to-height ratio, not just the visible glass. A quarter-inch of variance in the sash channel is enough to make a replacement sash bind. If the unit is a sliding patio door, note the panel configuration (two-panel, three-panel) and which side is the operating panel.
The OEM-versus-aftermarket call is more nuanced than it looks. For frames and sashes, aftermarket equivalents are fine when they match the profile. For locks, rollers, and weatherstripping, OEM or a direct-match aftermarket part is the safer bet, because a lock that’s off by a millimeter won’t engage the keeper and a roller with the wrong wheel diameter will jump the track. We source the right part for your model and tell you plainly which is which before you commit. We also service KraftMaid, Cambria, and Silestone products for Miami homeowners on the kitchen and bath side.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Windows & Doors Is Failing
These are the five symptoms we hear most in Miami, and what’s usually behind each one.
- Condensation or fogging between the panes. The glazing seal has failed and moisture has entered the air space. This one is not repairable on a sealed unit; the glass assembly gets replaced.
- A slider or patio door that drags or jumps the track. Usually worn rollers or a track that’s picked up grit and corrosion. Sometimes it’s a bent track from a past storm.
- The lock or latch won’t engage cleanly. A shifted sash, a worn keeper, or hardware that’s simply past its service life. In Miami’s humidity, metal hardware corrodes and the alignment drifts.
- Drafts or water intrusion at the frame. Failed weatherstripping, dried-out glazing bead, or caulk that’s broken down. Left alone, this is where water damage starts behind the wall.
- The sash won’t tilt or release for cleaning. A broken tilt-latch or a pivot bar that’s worn. This one is a small part with a big consequence: a sash that won’t secure is a wind-load concern during storm season.
If you’re seeing two or more of these on the same unit, the economics usually favor a full replacement over repeated part swaps.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what Miami homeowners typically see, installed, including labor and disposal:
| Project | Installed Range |
|---|---|
| Standard window replacement | $5,310 – $17,700 |
| Impact-rated window installation | $9,440 – $29,500 |
What drives the range: unit size and count, single-hung versus slider versus casement, whether the opening needs framing or stucco repair, and impact rating. Impact-rated units cost more because of the glass and the testing certification, and in Miami that’s often the right call. We pull the permit and coordinate the inspection on any project that requires it.
Pricing is upfront: the number you see is the number you pay, with parts and labor broken out line by line. Project costs over $10,000 qualify for $1,000 off, and we offer 0% financing for 18 months. Workmanship is covered by our 730-Day Done Right Promise.
DIY or Call Us?
Some checks are safe and worth doing yourself. You can look for the model label, inspect the weatherstripping for cracks, test the lock with the window closed, and clean and lubricate a slider track. Those cost nothing and tell you a lot.
Where DIY goes wrong: replacing a sealed glass unit, re-setting a sliding door panel, or swapping hardware on a second-story window. Glass is heavy and dangerous to handle, and an impact-rated unit installed without the correct anchoring doesn’t perform as an impact unit, which is a real safety and code issue in Miami. A door panel that comes off its track can fall. For anything beyond the four checks above, we recommend a trained professional. Call (833) 968-1198 and we’ll tell you honestly whether you need a part or a replacement.
FAQs
Expect 15 to 25 years for the frame and 10 to 15 years for the glazing seal and hardware in Miami’s salt-air and high-UV climate, which is shorter than inland markets. The seal is usually the first thing to go. Call (833) 968-1198 for an exact quote on your unit; estimates are free.
Sometimes. Hardware, weatherstripping, rollers, and locks are repairable and worth doing if the frame and glass are sound. A fogged sealed glass unit and a warped frame are not. We’ll tell you which situation you’re in before you spend anything.
Most single-unit replacements are done in a single visit. Multi-unit projects, impact-rated installs, and anything requiring a permit and inspection get a scheduled window, usually a matter of days, not weeks, depending on part availability for your model.
We identify your model from the label, etch, or frame profile, then source the exact-match part or a verified aftermarket equivalent and quote it in writing. We don’t stock parts and we don’t carry them on a truck, so the quote is based on your actual unit, not a guess.
If you’re in Miami and your Wellborn window or door has failed, call (833) 968-1198 for a free estimate. A live person answers 24/7, we’ll walk through what your unit needs, and you’ll get upfront pricing with no surprises. Backed by our 730-Day Done Right Promise, built to last, and backed in writing.
Written by the team at Groundwork Construction Co. of Miami, serving Miami and nearby areas.