Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Fence Installation: The Miami Owner’s Guide
We install Schluter-compatible fence installation for Miami homeowners, and the typical installed price lands between $4,130 and $10,620 depending on fence length, material, and gate count. If your existing system is failing, most swap-outs can be scheduled within the same week. Most owners don’t notice the problem until a post starts leaning after a summer storm, a gate drags on the pavers, or they spot rust bleeding through the finish along the bottom rail near the ground.

Miami’s salt air, wet season downpours, and year-round humidity put fence hardware through more than most of the country sees. A fence system that would last 15 years in a dry climate often shows its first real trouble here in half that time. The good news: when one component fails, you usually don’t need to replace the whole fence.
Which Schluter Models This Applies To
Schluter fence systems come in a few broad families: aluminum panel systems, composite/wood-look panels, and the hardware kits (posts, caps, brackets, gate hinges) that hold them together. The installation itself isn’t a single “part” you swap, it’s a system. But when a Miami owner calls us, it’s almost always one failed component within that system driving the whole repair.
Here’s how to identify what you actually have:
- Post caps and base plates usually carry a stamped or printed model code on the underside. Flip the cap and read it.
- Panel sections are measured by height (typically 4′, 5′, or 6′) and by panel width. Write down both before you call.
- Gate hardware is the most common failure point and the least standardized. Measure hinge spacing center-to-center.
OEM vs. aftermarket for Schluter specifically: genuine Schluter replacement hardware matches the finish and tolerance of your existing system, which matters most on aluminum and color-coated finishes where a slightly off match is visible from the street. Aftermarket equivalents cost less and work fine for hidden brackets and post bases, but for visible caps, hinges, and rail ends, we lean toward the genuine match. A common compatibility gotcha: post base plates from different production runs can differ by a few millimeters in bolt-hole spacing, so a base plate that looks identical may not bolt to your existing footing without re-drilling.
Groundwork Construction Co. of Miami is an independent service provider and is not affiliated with Schluter. We source what fits your system.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Fence Installation Is Failing
South Florida weather works on fences differently than the rest of the country. Here’s what we see, and what’s usually behind it:
- Posts leaning after a storm. The footing has shifted in Miami’s sandy, high-water-table soil, or the post base has corroded where it meets the ground. This is a footing and hardware problem, not a panel problem.
- Rust bleeding along the bottom rail. Salt air and standing moisture after heavy rain break down the finish at the lowest point, which is exactly where water pools. Once rust shows through, the coating is compromised.
- Gate dragging or sagging. Hinges wear faster in humidity, and wood-look or composite gates absorb moisture and swell. A dragging gate is usually a hinge and alignment fix, not a full replacement.
- Loose or rattling panels. The panel brackets or top rail fasteners have backed out, often from wind load during hurricane season. Tightening and replacing the fasteners usually solves it.
- Faded or chalky finish. UV exposure in Miami is intense year-round. Some finishes chalk and fade well before the structure fails, which is a cosmetic issue you can often live with or refinish.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a Schluter-compatible fence installation in Miami, the installed price typically runs $4,130 to $10,620. What drives the number:

- Linear feet and height – more panels and taller sections cost more.
- Gate count and hardware – gates are the single biggest cost swing, because hinges, latches, and alignment labor add up.
- Material family – aluminum and composite systems sit at different points in the range.
- Footing conditions – sandy Miami soil near the water table sometimes needs deeper footings.
We give you an upfront price with the parts and labor broken out, so you see what you’re paying for. The number you see is the number you pay. No change orders mid-job. And the work is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right.
DIY or Call Us?
You can safely do a few things yourself: check post caps for model codes, measure panel and gate dimensions, and tighten loose gate hinges with a screwdriver. Those are low-risk and help you get an accurate quote.
Where DIY goes wrong on a fence system is the footing and the structural hardware. A post that’s leaning because the footing has shifted needs to be reset and re-set properly, not just straightened and re-braced. Cutting corners there means the post leans again after the next wet season. Gate alignment and hinge replacement also need precise spacing, and a misaligned gate wears out its hardware fast. For anything structural, call us. We’ll tell you honestly whether you need a full install or a targeted repair.
Call (833) 968-1198 for a free estimate. Calls are answered by a live person, 24/7.
FAQs
Expect 10 to 15 years for aluminum systems and somewhat less for composite or wood-look panels in Miami’s salt air and humidity. The finish and hardware usually fail before the structure does. Call (833) 968-1198 for an assessment of what’s actually failing on your fence.
Yes, often. A leaning post, a dragging gate, or rusted hardware can usually be repaired without replacing the panels. We’ll tell you after we see it whether a repair makes sense or a full install is the better spend. Call (833) 968-1198 to schedule a free look.
Most fence installations run one to three days depending on length, gates, and footing conditions. A targeted repair of a single post or gate can often be done in a single visit. Call (833) 968-1198 for a time estimate on your specific fence.
We match the part to your model code and measurements, then source genuine or quality aftermarket equivalents depending on what’s visible and what’s hidden. You’ll see the parts cost broken out in your quote, so there’s no guessing. Call (833) 968-1198 to get started.
We also work with KraftMaid, Cambria, and Silestone across our kitchen and bath projects. Fence work is one of our seven core service lines, backed by the same 730-Day Done Right Promise and 0% financing for 18 months. Projects over $10,000 get $1,000 off. Call (833) 968-1198 for your free estimate and design consult. Groundwork Construction Co. of Miami – upfront pricing, no surprises, from foundation to finish line.
Written by the team at Groundwork Construction Co. of Miami, serving Miami and nearby areas.