Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Driveway & Pavers: The Miami Owner’s Guide
We install Schluter-compatible driveway and paver systems across Miami, and the most common paver-related failure we get called out for is a settlement or drainage fault at the edge restraint, not the part itself. If you’re replacing a paver driveway in Miami, plan on $8,260 – $21,240 installed for a full paver driveway, or $5,900 – $16,520 for a replacement over an existing base. Paver driveway installs are planned projects, not same-day emergency work, so we schedule an on-site estimate and quote the base, edge restraint, and drainage lines together.

Owners usually find the problem the same way. A paver lifts or rocks underfoot after a heavy afternoon storm. Water pools against the garage door and won’t drain. The decorative edge that met your lawn starts creeping into the grass after a few wet seasons. Schluter is best known for its tile and stone installation systems, and we get a fair number of calls from Miami homeowners who were told a Schluter profile or edge trim would solve a driveway transition. We’ll tell you straight what a Schluter system does and doesn’t cover on a driveway.
Which Schluter Models This Applies To
Schluter’s outdoor line is built around its tile and stone systems: profiles like SCHIENE, RONDEC, and TREP-B for edge protection and transitions, plus DITRA-DRAIN and TROBA-PLUS drainage and separation products. Those are designed for tile and hard-surface assemblies, and they perform well at a pool deck, a covered lanai, a front-entry tile landing, or a garage apron topped with pavers over a bonded base. They are not a paver base system, and they won’t fix a driveway that’s settling because the sub-base wasn’t compacted.
Identifying the right part starts with the assembly, not the brand label. Match the profile height to your paver thickness (a 2-3/8 in. paver needs a different edge profile depth than a 2-1/4 in. unit), measure the exposed edge you’re trimming, and confirm the joint width. Original Schluter profiles are extruded PVC or anodized aluminum, and the height tolerance is tight, so a profile that’s even 1/16 in. off shows at the transition.
OEM versus aftermarket: on a visible driveway edge, we specify the original Schluter profile when the assembly is Schluter-based, because it’s the part engineered to the drainage and movement spec. Aftermarket PVC trim can be fine for a purely decorative lawn edge, but “close enough” profile height is what causes the lippage complaint six months later. We’re an independent contractor and not affiliated with Schluter, so we match whatever the assembly calls for and tell you when a Schluter product is the wrong tool for the job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Driveway & Pavers Is Failing
- Ponding water against the garage apron. A drainage or slope failure, not an edge-profile failure. Miami’s flat lots and heavy summer rain expose a missed positive slope every rainy season.
- Paver lippage at the transition. One paver higher than its neighbor usually means base or edge restraint movement, and the profile is along for the ride; replacing the trim won’t stop it.
- Edge trim lifting or popping. Adhesive failure or shifting restraint below. Common where a decorative edge meets landscaped grass and the mow strip was never pinned.
- Cracked or delaminating profile. UV exposure, foot traffic on the trim, or an oversized deflection across a joint. Small cracks in the trim widen with temperature swings.
- Weeds and loose sand at the joint. The joint sand washed out and the edge isn’t holding. Left alone, this leads to base erosion that no top-down fix will cure.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what paver and driveway work runs in Miami, installed. The number you see is the number you pay.
- Paver driveway installation: $8,260 – $21,240
- Driveway replacement (over existing base): $5,900 – $16,520
- Concrete driveway installation: $5,310 – $14,160
- Asphalt driveway paving: $4,130 – $10,620
- Driveway sealing: $295 – $825
What drives the range: driveway square footage, base condition, edge profile running feet, drainage corrections, and paver type. The quote itemizes parts, base work, and labor separately, so you see what the Schluter-compatible profile line actually costs versus the repair beneath it. Every install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. Paver driveway work also qualifies for $1,000 off projects over $10,000 and 0% financing for 18 months, and the estimate and design consult are free.
DIY or Call Us?
Some of this you can check safely. Hand-test for loose pavers, look for the low spot where water pools, and confirm whether the edge trim is moving underfoot. Those three checks tell you whether the problem is at the surface or underneath.
Where DIY goes wrong is base diagnosis: lifting and resetting pavers over a failed sub-base with a bag of sand and a rubber mallet looks fixed and pools again by August. Grinding or cutting a new profile to fit is another trap, because a profile cut on site loses the drainage spec and starts holding water against the transition. And if the assembly sits on a raised or sloped edge at the house, work near the wall is where water intrusion into the slab starts. Call us at (833) 968-1198 and we’ll give you a straight read on whether it’s a trim swap or a base repair.
FAQs
Paver driveways typically hold their edge for 15 – 25 years when the base is right, and Schluter PVC and anodized aluminum profiles last 10 – 20 plus years if the assembly behind them stays tight. In Miami’s UV and rainy-season cycle, an edge profile that was installed with a thin adhesive bed is the first thing to let go. Call (833) 968-1198 for an exact quote before it turns into a base repair, and estimates are free.
Sometimes, yes. If the profile is sound and only the joint or restraint moved, a repair is often the right call. If a paver is rocking, the repair is base work under the paver, not a new profile. We assess the source before quoting a reinstall. Call (833) 968-1198, and we’ll tell you which one you’re facing.
A single-property paver driveway install typically runs 2 to 4 days depending on square footage, base condition, and drainage corrections, and a straight profile swap can be a same-day scope. Replacement over an existing base is often quicker than a new install. Call (833) 968-1198 to schedule your free estimate and get the timeline in writing.
We match the profile to your assembly spec, order the correct height and material, and we don’t claim to carry parts. Everything is sourced to the job, and if a Schluter product isn’t the right fit for a driveway edge, we’ll say so and quote the appropriate paver edge and drainage system instead. Call (833) 968-1198 for a free estimate.
Reach us at (833) 968-1198 for a free estimate on your Schluter-compatible driveway and paver work in Miami. Calls are answered by a live person 24/7, no voicemail, and a free project estimate and design consult is standing open. Our technicians have up to 12 years of experience, they arrive background-checked and in uniform, and your project is protected by the 730-Day Done Right Promise and upfront pricing. We also serve the Miami area on KraftMaid, Cambria, and Silestone work across other trades, but for a driveway that fails every rainy season, call (833) 968-1198 and let’s get the base right the first time.
Written by the team at Groundwork Construction Co. of Miami, serving Miami and nearby areas.