Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Jerith Home Additions & ADU: The Miami Owner’s Guide
We install Jerith-compatible home additions and ADU components across Miami, and whole-project additions run $53,100 – $153,400, with detached ADU construction at $106,200 – $259,600. Jerith is best known for aluminum fence and railing systems, so when an owner calls us about “a Jerith addition,” it’s usually a Jerith railing, gate, or enclosure element around a new addition or ADU rather than the structure itself, and we install and repair both sides of that work. Same-day availability is not realistic for an addition or ADU, and we won’t pretend otherwise: additions are permitted, inspected work measured in weeks.

Owners usually notice the failure runaround first. A Jerith aluminum rail section at the edge of a new addition starts to wobble at the post base, a gate on the ADU access path won’t latch squarely anymore, or a powder-coated finish turns chalky and pitted after a couple of Miami wet seasons. That’s when the “which part do I actually need” calls start, and where most homeowners get stuck.
Key Takeaways
- Jerith parts are matched by post size, rail spacing, and series profile, not by photo.
- Full home additions in Miami: $53,100 – $153,400. ADU construction: $106,200 – $259,600.
- Salt air and near-daily humidity drive finish failure on aluminum faster in Miami than inland.
- We’re an independent contractor, not affiliated with Jerith. We source the right component and do the install.
Which Jerith Models This Applies To
Jerith manufactures aluminum fence, railing, and gate systems, and its product lines are organized around residential and commercial profiles with distinct post caps, picket spacing, and panel heights. The part that fails around an addition or ADU is almost always a terminal post, a gate hinge or latch, a rail crossbar, or a post-mount base, and the model identity matters because a hinge that fits one Jerith series won’t seat correctly on another. The fastest way to identify your part: check the inside face of the gate frame or the underside of a post cap for the manufacturer sticker, then measure post width (commonly 2-inch and 2.5-inch residential sizes) and rail spacing center to center. Bring us those numbers plus a photo.
OEM versus aftermarket is a judgment call. Jerith OEM hardware keeps the original fit and finish, but a quality aftermarket stainless hinge or latch often outlasts the original in Miami’s salt-heavy air, and a marine-grade 316 stainless replacement is a defensible upgrade over a standard 304 grade where the piece sits close to Biscayne Bay or the ocean. We don’t stock parts and we don’t carry them on a truck; we identify the correct component, order it, and handle the install as part of a permitted addition or ADU project. This is exactly the model-match work we do for other lines too, including KraftMaid, Cambria, and Silestone cabinet and surface components.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Jerith Home Additions & ADU Is Failing
Here’s what a failing Jerith rail, gate, or enclosure component looks like in Miami conditions, and what’s actually happening underneath:
- Post base rock or wobble. The anchor or concrete footing has loosened, often from Miami’s sandy soil settling after heavy summer rain. Ignore it and the post works loose enough to stress the rail connections above.
- Gate drag and failed latch. A hinge has worn or bent, dropping the gate out of square. It shows up first on ADU access gates that get daily use, and the latch then won’t engage, which is a safety gap around any pool or enclosure.
- Chalky, pitted powder coat. Miami’s salt air and humidity eat through a compromised coating faster than inland climates allow. Once the aluminum underneath is exposed, oxidation is a slow but real structural problem.
- Loose pickets or rattling panels. Fasteners have backed out or a rail crossbar has fatigued. Wind load during hurricane season works these loose faster on exposed additions.
- Rust streaks at hinges and latches. The stainless hardware was a lower grade than the coastal exposure required. A 304-grade hinge near the water will spot and pit; 316 marine grade resists far better.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed pricing for the work Jerith parts belong to, calibrated to the Miami market:
| Project | Installed range |
|---|---|
| Home addition (whole project) | $53,100 – $153,400 |
| ADU construction | $106,200 – $259,600 |
| Garage conversion | $35,400 – $94,400 |
What drives the range: square footage, whether the addition is attached or detached, permitted footing and foundation work, and the railing or enclosure scope around the ADU access and pool areas. On the parts side, a single repaired gate hinge or replaced rail crossbar is a small line item; a run of new aluminum railing installed across a new addition is the larger variable. We’ll show you a written, line-item quote with parts and labor broken out, so the number you see is the number you pay – no change orders for materials that came in higher than quoted. Every project we complete is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. Estimates and design consults are free.
DIY or Call Us?
Some of this you can check safely. Walk the post bases and feel for wobble. Check that the gate latches fully and the hinges swing clean without drag. Look for rust streaks or chalky spots on the finish. Note those symptoms before you call, it’ll save time on the visit.
Where DIY goes wrong: digging around a set post to re-anchor it, replacing a hinge on a gate that’s out of square, or re-coating exposed aluminum without stripping the chalk first. Those fixes fail within a season, and a re-anchored post that’s still loose is a safety issue. If your addition or ADU involves structural framing, electrical, or any permit-pulled scope, that’s not DIY territory at all. Call us at (833) 968-1198 and we’ll tell you straight whether it’s a small parts replacement or a bigger scope, and line up the right fix. Our technicians have up to 12 years of experience, arrive background-checked and uniformed, and a live person answers the phone around the clock.
FAQs
Jerith’s aluminum systems typically hold up for 15 to 20 years or more in a well-maintained install, but Miami’s salt air and humidity shorten that noticeably near the coast, so budget for finish touch-ups and hinge or latch replacement well before the structure itself needs replacing. Call (833) 968-1198 for a free estimate on yours.
Usually yes – a hinge, latch, post cap, or single rail crossbar can often be swapped without replacing the full railing run. The deciding factor is whether the post base and frame are still square and sound; if they are, a targeted parts swap saves real money. We’ll tell you which path is honest at the estimate.
A single hinge, latch, or rail piece is typically a same-visit job of a few hours once the correct part is on hand, while a full railing run around a new addition takes longer and a full addition or ADU is measured in weeks. Call (833) 968-1198 to book a free estimate and we’ll give you a real timeline, not a guess.
We match the component to your model using the sticker, post width, and rail spacing, then order through Jerith’s supply chain – or a quality marine-grade aftermarket equivalent where it’s the better long-term choice for coastal Miami exposure. We don’t stock parts, so we confirm fit before ordering. Call (833) 968-1198 to start the match.
An addition or ADU is one of the largest investments you’ll make on your Miami property, and the parts and enclosure work around it deserve the same care. Groundwork Construction Co. of Miami handles it from foundation to finish line, backed in writing by the 730-Day Done Right Promise, with upfront pricing and no surprises, plus $1,000 off projects over $10,000 and 0% financing for 18 months. Call (833) 968-1198 for a free estimate and design consult.
Written by the team at Groundwork Construction Co. of Miami, serving Miami and nearby areas.