Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Gladeview, FL: What It Takes and What It Costs
Door Installation in Gladeview typically runs $650 to $3,200 per opening, depending on whether we’re setting a standard exterior slab, a wind-rated entry system, or a heavy shop door on a detached outbuilding. Most single-door swaps are a one-day job; entry systems that need framing correction or a county inspection run two to three days. Call (833) 968-1198 and we’ll give you a real number for your actual door.
How We Run a Door Job, Start to Finish
No two doors are the same, but the sequence on a Gladeview job is consistent. Here’s what actually happens, stage by stage, so you know what you’re paying for and when you have to make a call.
- Day 1, morning – measure and open the wall: We pull the existing door and casing, check the rough opening for rot, and confirm the framing is square. On mid-century masonry homes in 33147 this is where surprises show up: rotted sill plates, a header that was never tied in, or a cheap door shimmed into an out-of-square opening. Budget an hour for demo, another hour inspecting.
- Day 1, midday – prep and flash: We repair or replace damaged framing, then flash the rough opening correctly before anything goes in. This is the step most quick installs skip, and it’s why so many new doors leak in the first big summer storm. Roughly two hours, longer if there’s structural repair.
- Day 1, afternoon – set and shim the unit: The door goes in plumb, level, and square, shimmed at the hinges and lock side. You’ll want to decide your hardware and finish before this point, because the door is drilled and hung around it. This stage takes two to three hours.
- Day 2 – insulation, trim, and sealant: Low-expansion foam around the frame, interior and exterior trim, a continuous bead of sealant on the outside. This is the day the job starts looking finished. You’ll pick your casing profile and paint color here. Three to four hours.
- Day 2 or 3 – inspection and final walkthrough: If the door is on an exterior wall or an addition, Miami-Dade County wants to see it. We schedule the inspection, walk the job with you, and demonstrate the latch, the weatherstrip seal, and the deadbolt before we leave.
Two things move that timeline: whether the opening needs structural repair, and whether the county has to inspect. A like-for-like interior door swap is a half-day. A wind-rated front entry on an older masonry wall can stretch to three.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Exterior, Interior, Shielded, or Shop: What You’re Choosing Between
Most Gladeview homeowners are choosing between four categories, and the honest trade-offs are worth spelling out before you pick.
- Standard exterior door (steel or fiberglass, non-impact): the lower-cost route, roughly $650 to $1,400 installed. Holds up fine, but not rated for the High-Velocity Hurricane Zone. Suits a carport side door or a rear door that’s protected by a shutter.
- Wind-rated impact entry door: $1,200 to $3,200 installed. The right choice for a front entry or any opening that isn’t going to be shuttered. Brands like PGT and CGI make door systems that carry the product approval Miami-Dade will accept without a fight. Heavier than a standard door, so the hinges and closer matter.
- Interior doors (hollow-core or solid-core slab): $350 to $850 per opening installed. Solid-core buys you a quieter house and a door that won’t hollow out after ten years. Hollow-core is fine for closets and storage rooms.
- Heavy-duty shop and outbuilding doors: the Gladeview specialty. Detached workshops and oversized garages need a door rated for the wind load and a frame that can carry the weight. Prices run higher because the hardware and the header work to support the door run higher.
We also set Boral and CWS trim and door components where a homeowner wants the finish to match the rest of the exterior, and we’ll tell you straight when the cheaper door is the right door for the opening.
What Door Installation Costs in Gladeview, FL
Expect $650 to $3,200 per door installed, with most Gladeview jobs landing in the $900 to $1,800 range for a single wind-rated exterior entry or two interior doors. Here’s what pushes a job to the low end versus the high end.
- Wind rating: the single biggest lever. A non-impact door is cheaper up front; an impact-rated door costs more but avoids the shutter headache every June and satisfies the county. This is a $500 to $1,500 swing on its own.
- Opening condition: a clean, square rough opening keeps the job quick. Rotted framing, a sagging header, or an unpermitted addition behind the wall adds repair labor and time.
- Structural work: widening an opening or moving it means framing, header, and drywall repair. That’s where a door swap turns into a construction project.
- Material and hardware grade: a builder-grade interior slab versus a solid-core door with a good lock set is a real spread. Same for exterior hardware on a wind-rated system.
- Permit and inspection scope: a straight swap inside the existing opening may not trigger a permit. A new exterior opening, a relocated door, or a door on an addition will, and the county inspection adds time and cost.
Your written estimate lists the door, the hardware, the framing repair allowance, the sealant and trim, the permit if one applies, and the labor. What it can’t price until we’re on site is hidden rot; that’s why we open the wall. The number we put on paper is the number you pay. And our Windows & Doors in Gladeview page shows how a door fits into a larger envelope project if you’re planning more than one opening.
See the difference
Before
After
Before
After
Before
AfterWhy Gladeview Doors Are Their Own Job
Gladeview sits in unincorporated Miami-Dade, which means there’s no city hall to walk a permit through. Everything runs through the county, and the county runs it under High-Velocity Hurricane Zone rules and strict product-approval requirements. That’s the reality on every door job here. A door on an exterior wall needs wind-borne-debris-rated hardware and product approval on the books, and any new opening gets inspected. Neighboring Hialeah or Miami proper have their own processes; Gladeview doesn’t, so we plan for county timelines from the start.
The housing stock shapes it too. Much of 33147 is 1940s to 1960s concrete-block and terrazzo homes, many expanded over the decades with unpermitted room additions, converted carports, and rear add-on units. On nearly every door we install in a converted carport or an add-on room, the opening isn’t where the original drawings say it is, and the framing behind the drywall may never have been inspected. That’s why we survey before we cut and why we’ll flag when an unpermitted add-on has to be brought to code. The subtropical climate does the rest: high humidity and intense UV eat cheap doors and hardware fast, and the June to November storm season is why wind rating isn’t optional.
Serving Gladeview, FL – Our Local Coverage Area
We serve Gladeview and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Gladeview
Most single-door installs take one day, and two-to-three-day timelines are for wind-rated entry systems, framing repair, or jobs that require a county inspection. Interior door swaps are usually a half-day. Call (833) 968-1198 and we’ll give you a realistic timeline for your opening.
A straight replacement inside an existing opening often doesn’t require a permit, but a new exterior opening, a relocated door, or a door on an addition does, and it goes through Miami-Dade County rather than a city office. We tell you which category your job falls into before we quote. Call (833) 968-1198 for an exact scope.
Yes, in most cases. If the new door fits the existing rough opening, there’s no framing, plumbing, or structural work involved. Widening an opening or relocating a door is a different job and gets priced accordingly. Call (833) 968-1198 and we’ll confirm which you’re looking at.
Roughly $650 to $3,200 per door installed, with wind-rated exterior entries in the $1,200 to $3,200 range and interior slabs around $350 to $850. The variables are wind rating, opening condition, structural work, and permit scope. Call (833) 968-1198 for a free estimate with a line-itemed quote.
Every door we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s backed in writing and covers our workmanship for two years. Call (833) 968-1198 with questions about coverage on your specific door.
Get a Free Door Installation Estimate in Gladeview
If you’re planning a door for your Gladeview home or workshop, start with a free on-site estimate. We’ll measure, look at the opening, and give you a written number with the door, hardware, labor, and permit scope broken out. Call (833) 968-1198 to schedule. A live person answers day or night, and our technicians arrive background-checked and in uniform. Homeowners often pair this with Chain Link Fence in Gladeview or Vinyl Fence in Gladeview to close off the yard around an outbuilding, and you can see the full scope on our Windows & Doors service page. We cover all of Gladeview, including the NW 79th St corridor and surrounding blocks.
Written by the team at Groundwork Construction Co.