Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Windows & Doors: The Miami Owner’s Guide
We install and repair CWS windows and doors across Miami, and most CWS-related service calls fall into a predictable price band: window replacement runs $5,310 – $17,700, and impact window installation with CWS-compatible glass and hardware runs $9,440 – $29,500 depending on size, opening count and whether the frame is reused. Groundwork Construction Co. of Miami is an independent service provider and is not affiliated with CWS; we work on CWS units every week and we quote the number you’ll actually pay.

Owners usually figure out something is wrong the same way. A door that used to close with one finger now needs a shoulder. The sliding patio panel scrapes along the bottom track. A window crank spins freely and the sash won’t budge. Or the glass fogs from the inside and no amount of wiping helps. In Miami, humidity and hurricane-season pressure cycling speed all of this up, so a part that “failed early” on your CWS unit may simply have lived a hard life near the coast.
Which CWS Models This Applies To
CWS builds several product families – single-hung and double-hung vinyl windows, horizontal sliders, casement and awning units, patio sliding doors, and impact-rated lines built for Florida wind zones. The part you need is tied to the series, not just the brand, so the right move is to identify the unit before you order anything. Open the sash or panel and look for the manufacturer label etched or stickered on the top or side of the frame. It will list the series, the size, and often the glass package and impact rating. Photograph it. Then measure the visible glass width and height, the frame depth, and the track or hinge spacing if the part is a roller or a hinge.
On the OEM-versus-aftermarket question, we’re direct: for CWS hardware like rollers, cranks, locks, hinges and weatherstrip, a quality aftermarket equivalent is often the smarter buy because it matches the spec and costs less. For glass, sash assemblies and anything impact-rated, stay with OEM-matched parts. Florida’s wind-borne debris requirements run on the rated assembly, and swapping in unrated glass or a mismatched sash can void the rating on that opening even if it looks identical. If your unit is a screen door or a simple slider, an aftermarket roller set fits fine. If it’s impact-rated, spec matters. We confirm the series and the rating before we order, and we tell you which side of that line your part falls on.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CWS Windows & Doors Is Failing
- The door drags or won’t latch. Usually worn rollers, a bent track, or a hinge that’s lost its pin tension. In Miami, heat expansion and salt air accelerate both.
- The crank spins but the sash won’t move. The operator arm or gear has stripped. Common on casement and awning units after years of opening against wind.
- Fogging or condensation between the panes. The sealed glass unit has lost its seal. That’s a glass replacement, not a cleaning problem.
- Water on the interior sill after rain. Failed weatherstrip, clogged weep holes, or a sash that no longer seats square in the frame. Left alone, it rots the surrounding wood and drywall.
- A visible gap at the lock or a sash that won’t close tight. Worn lock hardware or a shifted frame. On impact-rated CWS units, a sash that won’t seat fully means the unit may not perform as rated in a storm.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed pricing for CWS-compatible work in Miami:
- Window replacement (standard, non-impact): $5,310 – $17,700 installed.
- Impact window installation: $9,440 – $29,500 installed.
- Hardware and parts swaps (rollers, cranks, locks, weatherstrip): quoted line by line before work starts.
What drives the range: opening size, count, whether the frame is reused or replaced, glass package, and impact rating requirements for your wind zone. We write the quote as line items – parts, labor, disposal – so you see exactly what you’re paying for. The number you see is the number you pay, no change orders mid-job. All our work is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right.
DIY or Call Us?
Here’s the honest split. You can safely check and, in many cases, handle the small stuff: clean and clear the weep holes, replace weatherstrip on a standard slider, swap a screen, tighten a loose lock plate, and clean the track so rollers run free. What goes wrong in DIY territory is glass work and impact-rated assemblies. A sealed glass unit that’s been compromised can’t be repaired with caulk, and reseating an impact sash without the right hardware and seal defeats the rating that protects your home in a storm. Door and window glass work also carries real injury risk – broken glass, a sash that drops, a unit that comes out of the frame wrong. For anything impact-rated, or any glass replacement, let a trained technician handle it. Call (833) 968-1198 and we’ll tell you straight whether it’s a parts swap or a full unit.
FAQs
How long do CWS windows and doors last in Miami? Standard CWS vinyl and aluminum units typically hold up 15 – 25 years, but in Miami’s salt air and humidity, hardware and weatherstrip often need replacing around the 7 – 10 year mark. Impact glass units can last longer, but a failed seal shows up sooner. Call (833) 968-1198 for an assessment of your specific units.
Can it be repaired instead of replaced? Often yes. Rolls, cranks, locks, hinges and weatherstrip are repair items; fogged glass and a sash that’s out of square usually mean replacement. We’ll tell you which one you’re facing before we quote.
How long does the swap take? A hardware or weatherstrip swap is typically done in a single visit. A window or sash replacement is usually a few hours per opening. We schedule around your day, and we answer the phone live, 24/7.
How do you source the part for my CWS unit? We match on the series and label information, confirm whether an OEM or quality aftermarket equivalent is the right spec, and order to that match. We don’t claim to stock CWS parts or carry them on a truck – we identify your unit and source the correct part, then install it.
We also work with KraftMaid, Cambria and Silestone on the interior side of your home. Whether it’s one failed CWS window or a full set of openings, we’ll give you a straight quote, a live person on the phone, and work backed in writing. Call (833) 968-1198 for a free estimate, and take advantage of $1,000 off projects over $10,000, 0% financing for 18 months, or our free project estimate and design consult.
Written by the team at Groundwork Construction Co. of Miami, serving Miami and nearby areas.