Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Home Additions & ADU: The Miami Owner’s Guide
Installing Schluter-compatible home additions and ADU systems in Miami typically runs $53,100 to $153,400 for a full addition, with ADU construction at $106,200 to $259,600. Schluter waterproofing and uncoupling membranes are usually the first thing we lay down on a slab addition, and a failed one shows up as a hollow tile, a lifted grout line, or a dark stain creeping up a new wall baseboard. If you’re pricing a repair or a fresh build, call (833) 968-1198 and we’ll walk your exact scope with you. We’re an independent contractor, not affiliated with Schluter.

Groundwork Construction Co. of Miami has been building in South Florida since 2014, and every project carries our 730-Day Done Right Promise – if it’s not done right, we make it right. Live person on the line, 24/7.
Which Schluter Models This Applies To
Schluter’s system spans a few families, and the part you actually need depends on which surface failed. The big three for additions and ADUs:
- DITRA / DITRA-HEAT – uncoupling and heating membranes. DITRA comes in 3/8″ (10mm) and 5/16″ (8mm) profiles; DITRA-XL is the 5/16″ version for larger tile formats. Match the profile exactly or your finished floor height shifts against the adjoining room.
- KERDI / KERDI-BAND – the waterproofing membrane for shower and wet-area walls. KERDI-BAND is 5″ wide; KERDI-FLEX is the 5″ flexible version for corners and transitions. Using the wrong width at a pan-to-wall joint is the most common install error we correct.
- KERDI-DRAIN / KERDI-LINE – the drain assemblies. The KERDI-DRAIN has both ABS and PVC versions; if you order the wrong plastic, the drain body won’t bond to your plumbing.
How to ID what you have: look for the printed brand strip on the membrane edge, check the thickness with calipers if the stamp has worn, and photograph the drain body from below before you remove it. OEM Schluter membranes matter more than generic uncoupling products because the fleece anchoring is what makes the system bond. Aftermarket “equivalent” membranes run cheaper but don’t carry the same thinset compatibility – and in a Miami addition where a slab can hold moisture, that’s the difference between a floor that lasts and a call-back.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Home Additions & ADU Is Failing
- Hollow-sounding tiles. You tap a tile and hear a dead thud instead of a tight click. That’s usually lost bond under the membrane – often a thinset that was dry or a substrate that moved before the mortar cured.
- Lifted or cracked grout lines. Hairline cracks that reappear after re-grouting point to movement the membrane was supposed to absorb. In Miami, slab additions that don’t get a proper uncoupling layer will telegraph every crack straight through.
- Efflorescence or a white powder at wall bases. That’s moisture migration – the KERDI band failed at a seam or the flange wasn’t sealed. Common in showers where the pan-to-curb junction wasn’t overlapped correctly.
- Water staining at the drain. A dark ring around a KERDI-DRAIN tells you the waterproofing membrane and the drain flange have separated. Fix it before the ceiling below tells you.
- Loose or shifting tile at the perimeter. Movement at the edge of the room usually means the membrane wasn’t run far enough or wasn’t bonded at the wall joint. Easy to check, and better checked early.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a Miami addition or ADU with Schluter waterproofing and uncoupling, the installed range breaks down like this:
- Home Addition: $53,100 – $153,400
- ADU Construction: $106,200 – $259,600
- Garage Conversion: $35,400 – $94,400
What drives the range: square footage, whether the slab needs moisture remediation before the membrane goes down, tile format (large-format tile needs the 5/16″ DITRA-XL profile), and whether a shower or wet-area system is part of the scope. Our pricing is upfront, no surprises. Materials and labor are itemized on the quote, and the whole job is covered by the 730-Day Done Right Promise. The number you see is the number you pay.
DIY or Call Us?
You can safely check a few things yourself: tap and listen for hollow tile, look for efflorescence at wall bases, photograph any stamped membrane edge, and check the drain flange seal with a flashlight. What you shouldn’t do is cut out and reinstall a waterproofing membrane or reset a KERDI-DRAIN yourself. A compromised shower pan or wet-area system means water goes where it shouldn’t, and Miami’s humidity will find it fast. Membrane installation also has a strict thinset and cure window that’s easy to miss without a moisture meter and the right notch trowel. If your inspection says a repair is due, call (833) 968-1198 for a free estimate and a straight answer on scope.
FAQs
How long does a Schluter system last in a Miami addition? A properly installed Schluter uncoupling or waterproofing membrane should hold up 30+ years on a slab addition, but that assumes the substrate was dry when it went down and the thinset cured correctly. Miami’s humidity makes a wet slab the number one killer – verify moisture before install or the membrane will fail early. Call (833) 968-1198 for an inspection and exact quote; estimates are free.
Can the part be repaired instead of replaced? Sometimes. A localized KERDI-BAND seam can be patched with matching band and thinset if the membrane underneath is still sound. A failed DITRA sheet across a whole room usually needs to come up – patching a lifted membrane just traps the moisture. We’ll tell you which one you’re looking at after a walk-through. Call (833) 968-1198.
How long does the swap take? A shower-pan membrane replacement is typically a 2 to 3 day job with cure time; a full-room DITRA replacement in an addition is usually 3 to 5 days depending on tile demo. ADU-scope re-membrane work takes longer and we’ll give you a written timeline on the quote. Call (833) 968-1198.
How do you source the Schluter part? We order through authorized distributors to match your exact profile and drain model, which means you get the genuine DITRA, KERDI, or KERDI-DRAIN part, not a lookalike. Tell us the stamped model number or send a photo and we’ll confirm compatibility before we quote. Call (833) 968-1198 for a free estimate.
We also service KraftMaid, Cambria, and Silestone materials in the same additions and ADU scope – one contractor, from foundation to finish line. Curious about the parts before you call? Send a photo of the membrane stamp or the drain body, and we’ll confirm exactly what you have.
Call Groundwork Construction Co. of Miami at (833) 968-1198 for a free estimate on your Schluter home addition or ADU in Miami. Live person answers, 24 hours a day, 7 days a week. Background-checked, uniformed technicians on every job. Upfront pricing, no surprises. 0% financing for 18 months and $1,000 off projects over $10,000 available.
Written by the team at Groundwork Construction Co. of Miami, serving Miami and nearby areas.