Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Olympia Heights: What the Job Actually Involves
Replacing a bathroom vanity, re-tiling a floor or shower surround, and upgrading fixtures in Olympia Heights typically runs $9,000 – $28,000 for a full bath’s worth of work, or $800 – $3,000 for a vanity on its own, and most jobs finish in three to eight working days once materials are on site. Vanities, tile & fixtures work is narrower than a full remodel: we’re replacing the visible surfaces and the plumbing trim, not moving walls. Call (833) 968-1198 and we’ll walk your bathroom and give you a written, line-item estimate.
How We Run a Vanities, Tile & Fixtures Job, Start to Finish
Every job follows the same five stages, and we tell you up front which days you’ll lose water or power and which days the house stays fully usable.
Stage 1: Walkthrough and written scope (day 0)
We measure the vanity footprint, check the shutoffs and drain locations, and confirm whether the existing tile is on a mortar bed or a modern cement board. That one detail decides how much demo is involved. You get a written estimate with the numbers broken out by vanity, tile, and fixtures, so you can see what each piece costs before you commit.
Stage 2: Demo and prep (day 1)
We pull the old vanity, fixtures, and tile, then inspect what’s underneath. In Olympia Heights’s older homes this is where we find soft subfloor near the tub or a shutoff that’s seized. We replace what’s failed and move on; we don’t tile over a problem. Water stays off for most of this day, so plan around it.
Stage 3: Rough-in and waterproofing (day 2)
If the new vanity shifts a supply line or drain, that happens here. Then we set cement board and roll on a bonded waterproofing membrane. We use Schluter systems on shower and wet-floor assemblies because the membrane and the drain flange tie together as one continuous layer, which matters in a climate that runs humid most of the year. This is the stage where we pause and check before anything gets covered.
Stage 4: Tile setting and grout (days 3 – 5)
Floor and wall tile go down, then cure before grout. Large-format tile takes longer to set than a mosaic because each piece has to be flat and level; a small hex tile goes faster but needs more grout attention. Your decision point here is layout: where the tile starts, how cuts land at the door and the corners, and whether you want a niche or a bench built into a shower wall.
Stage 5: Vanity set, fixtures, and final walkthrough (days 6 – 8)
The vanity cabinet gets set and leveled, the top and sink go on, and we install the faucet, shower trim with a new Delta or American Standard valve, towel bars, and the mirror. Then we run every fixture and check for drips under pressure. You walk the room with us before we call it done.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Most of the back-and-forth on a vanities, tile & fixtures job comes down to a handful of decisions. Here’s the honest version of each.
- Vanity type: A freestanding cabinet is the fastest and least expensive route. A floating vanity looks sharper in a small bath but needs blocking in the wall, so it adds framing time. A furniture-style vanity with a furniture-grade finish (KraftMaid builds these well) costs more but holds up better against steam than a stock cabinet.
- Countertop material: Cultured marble is the budget pick and stains over time. Quartz and granite cost more but shrug off water and cleaning products. For a busy household, quartz is usually the smarter spend.
- Tile material: Porcelain is the workhorse: dense, low-absorption, handles Florida humidity. Natural stone looks richer but needs sealing. Ceramic is the least expensive and fine for walls, less so for floors.
- Tile size: Large-format (12×24 and up) means fewer grout lines to clean and a more modern look. Small mosaic on a shower floor gives better grip underfoot.
- Fixtures: A standard chrome or brushed-nickel faucet is inexpensive and reliable. Upgrading to a comfort-height toilet (Toto makes several) is worth it if anyone in the house has knee or back issues.
What Vanities, Tile & Fixtures Costs in Olympia Heights, FL
Plan on $9,000 – $28,000 for a full vanities, tile & fixtures scope across a typical Olympia Heights bathroom, with a vanity-only swap landing around $800 – $3,000. The range is wide because five things move it:
- Size of the bathroom: A hall bath and a primary bath are different jobs. More square footage means more tile, more adhesive, more labor hours.
- Condition of what’s underneath: A failed subfloor or a corroded valve adds repair cost that no one sees until demo day.
- Moving plumbing or electrical: Keeping the vanity and toilet where they are keeps cost down. Relocating a drain or adding a GFCI outlet adds scope.
- Material grade: Porcelain versus natural stone and cultured marble versus quartz swing the number by thousands.
- Permit scope: A straight finish swap may not need a permit; relocating plumbing or changing the room’s layout usually does, and that adds inspection time.
A written estimate from us itemizes materials, labor, and permit fees separately, so there are no surprises when the invoice lands. What it usually doesn’t include: structural repairs found behind a wall, or a full layout change (that’s a bigger conversation).
See the difference
Before
After
Before
After
Before
AfterWhat Olympia Heights Homes Specifically Do to This Job
Most of the housing stock here is single-story concrete-block and stucco ranch homes built from the 1950s through the 1970s, and that changes how a vanities, tile & fixtures job goes. Original bathrooms in these homes often sit over a mortar-bed tile floor, which is thick and heavy to remove and sometimes hides a mud-set drain. Many still have original terrazzo in the hall, so we protect it carefully before demo starts. The subtropical marine climate matters too: high humidity and heavy summer downpours mean we spec continuous waterproofing and mold-resistant board in every wet area, not just behind the shower. And because this is unincorporated Miami-Dade, work that touches plumbing or layout runs through county permitting, where the paperwork wants product approval documentation. We assemble that package before we start so an inspection doesn’t stall the job halfway through. If your project grows past surfaces into a full layout change, that’s where our Bathroom Remodeling in Olympia Heights scope comes in, and it’s handled by the same crew.
Serving Olympia Heights, FL – Our Local Coverage Area
We serve Olympia Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Vanities, Tile & Fixtures in Olympia Heights
Most jobs run three to eight working days once materials arrive. A vanity-only swap can be a single day; a full tile and fixture replacement across a bathroom sits at the longer end. Call (833) 968-1198 for a timeline based on your specific room.
A finish-level replacement usually doesn’t require a permit, but relocating a drain, moving a supply line, or changing the room’s layout does. We pull the permit and handle the inspection when the scope calls for it, and we tell you which side you’re on before the estimate is signed.
Yes, and it’s the most common way we work. Keeping the vanity, toilet, and shower where they sit keeps the job in the finish category, which means less cost and less disruption. If the fixtures are in the wrong place, we’ll show you what moving them adds before you decide.
Expect $9,000 – $28,000 for a full bathroom’s worth of vanities, tile & fixtures, or $800 – $3,000 for a vanity alone, depending on size, materials, and whether anything underneath needs repair. Call (833) 968-1198 for an exact quote; estimates are free.
Every vanities, tile & fixtures project is covered by our 730-Day Done Right Promise. If something isn’t done right, we make it right. Pricing is upfront and written, so the number you see is the number you pay.
Get a Free Estimate on Vanities, Tile & Fixtures in Olympia Heights
We’ll come out, measure the room, check what’s under the old tile and vanity, and hand you a written line-item estimate with no pressure to sign on the spot. Calls are answered by a live person 24/7, and our technicians have up to 12 years of experience. If you’re pairing this with roof work on the same home, we also handle Tile Roofing in Olympia Heights and Specialty Roofing in Olympia Heights. Call (833) 968-1198 to schedule your free estimate, or read more about our Bathroom Remodeling service and the Olympia Heights area we cover.
Written by the team at Groundwork Construction Co..