Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Backsplash, Tile & Flooring in Fountainebleau, FL: What the Job Actually Involves
Backsplash, tile & flooring work in Fountainebleau typically runs $14,000 – $45,000 when it’s part of a full kitchen scope, and a backsplash alone lands between $800 and $2,500. A backsplash install is usually a one-to-two-day job; tile flooring across a kitchen or a condo unit runs three to six days depending on square footage and whether the old floor comes up. Call (833) 968-1198 and we’ll walk through your Fountainebleau unit, measure, and put a written number in front of you before anything gets demoed.
How We Run a Tile and Backsplash Job, Step by Step
Most Fountainebleau jobs we quote follow the same five-stage sequence. The stages don’t change much; what changes is how much prep a 1980s concrete-block kitchen needs versus a newer townhome.
Stage 1: On-site measure and material selection (day 1)
We measure every wall and floor plane, check for out-of-square corners and hollow-sounding tile, and photograph the substrate. You pick your tile at this stage, not later, because lead times on imported porcelain can run two to three weeks. This is also where you decide grout color, tile layout (stacked, offset, herringbone), and whether you’re going with a Schluter edge profile or a bullnose finish at the counter seam.
Stage 2: Demo and substrate prep (days 2 – 3)
Old backsplash comes off, old flooring comes up, and we assess what’s underneath. On Fountainebleau’s older condos, that often means finding drywall that’s been compromised by decades of humidity, or a slab that needs self-leveling before anything goes down. Prep is the stage nobody wants to pay for and everybody needs. Skipping it is how you get tile that pops loose in two years.
Stage 3: Layout and dry-fit (day 3 or 4)
We snap the layout lines and dry-fit a course before any thinset gets mixed. This is where you see your tile on the wall and have a last chance to change the grout line width or adjust where the pattern breaks around an outlet. On a backsplash, the outlet cutouts are the tell of a good install. We plan those before we cut.
Stage 4: Install (days 4 – 7, depending on scope)
Backsplash goes up in a single day on most jobs. Floor tile runs two to four days for a typical kitchen, longer if we’re tiling under appliances or setting a Schluter uncoupling membrane first. You’re out of the kitchen during install, so plan for a few days of takeout.
Stage 5: Grout, seal, and walkthrough (final day)
Grout cures, we seal where it matters, we clean the haze off, and we walk the job with you. Anything that isn’t right gets fixed before we call it done. That walkthrough is backed by the 730-Day Done Right Promise – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Backsplash, Tile & Flooring
Here’s what actually gets picked in Fountainebleau kitchens, with the honest trade-off on each:
- Porcelain vs. ceramic backsplash. Porcelain is denser, holds up better to steam and grease, and costs a bit more per square foot. Ceramic is cheaper and easier to cut for an outlet-heavy wall, but it chips more readily and stains easier over time.
- Large-format vs. subway tile. Large-format (12″x24″ and up) means fewer grout lines to clean, but it exposes any wall that’s out of flat. Subway reads classic and forgives a wavy wall. That forgiveness matters in older Fountainebleau kitchens where the drywall wasn’t hung to modern tolerances.
- Porcelain plank vs. LVT for flooring. Porcelain plank looks like wood, handles Florida humidity without swelling, and lasts decades. LVT is cheaper, warmer underfoot, and faster to install, but it doesn’t hold resale value the way tile does in this market.
- Schluter vs. bullnose edges. A Schluter profile gives you a clean metal or PVC edge at the counter seam without a separate trim piece. Bullnose is more traditional and color-matched to your tile. Schluter tends to win on modern layouts.
- Grout: cementitious vs. epoxy. Cementitious grout is cheaper and easier to work; epoxy grout resists staining and mold far better in a humid climate. For a backsplash behind a range, epoxy is usually worth the upgrade.
What Backsplash, Tile & Flooring Costs in Fountainebleau, FL
For a kitchen-scope tile and backsplash project in Fountainebleau, expect $14,000 – $45,000. That range covers the full kitchen when tile, backsplash, and finish work are part of the job; a standalone backsplash runs $800 – $2,500, and backsplash installation on its own typically lands at the low end of that. Here’s what pushes a job toward the bottom or top:
- Square footage and layout complexity. A straight galley wall is cheap to tile. A kitchen with an island, a peninsula, and a window bump-out takes more cuts and more time.
- Condition of what’s underneath. A floor that needs leveling or a wall with water damage from an old leak adds prep cost. On 1970s – 2000s concrete-block buildings, that’s common.
- Material grade. Imported porcelain and natural stone sit at the top; basic ceramic sits at the bottom. Grout and trim choices move the number too.
- Moving plumbing or electrical. Relocating an outlet or a sink line means a licensed trade and a permit pull, which adds to the scope. If you’re staying put, the number stays lower.
- Permit scope. A cosmetic tile swap usually doesn’t trigger a permit; moving a gas line or a wall does. We handle the paperwork either way.
Every written estimate we hand you is line-item: tile, setting materials, labor, prep, permits if applicable, and demo. No change orders sprung on you mid-job. If a number isn’t in the estimate, it doesn’t get added without your say-so.
See the difference
Before
After
Before
After
Before
AfterWhat Fountainebleau’s Building Stock Does to This Job
Fountainebleau (33172) is unincorporated Miami-Dade, and the housing stock here shapes the work. Most of what we walk into is 1970s – 2000s concrete-block and masonry – mid-rise condos, garden apartments, and townhomes with stucco-over-CMU walls. That’s a different starting point than a wood-frame house, and the substrate work reflects it. Kitchens in these buildings often have a slab floor that’s been patched more than once, and backsplash walls that aren’t as flat as the tile wants them to be.
Miami-Dade’s product-control (NOA) system for hurricane-rated materials also matters here. Any material that touches the building envelope – and in a kitchen, that includes exterior wall tile – has to meet the county’s stricter approval process, which means more paperwork than you’d deal with in most neighboring jurisdictions. We handle that documentation on our end. We also schedule around the June – November storm season, since afternoon thunderstorms and permitting crunches can stretch a project timeline. If your Fountainebleau job is part of a bigger kitchen scope, the work ties into Kitchen Remodeling in Fountainebleau; the trade sequence has to line up.
Serving Fountainebleau, FL – Our Local Coverage Area
We serve Fountainebleau and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Backsplash, Tile & Flooring in Fountainebleau
A backsplash alone is usually one to two days; tile flooring across a kitchen runs three to six days. Larger kitchens, older slabs that need leveling, and imported tile with long lead times push the total higher. Call (833) 968-1198 with your square footage and we’ll give you a realistic timeline for your Fountainebleau unit.
Cosmetic tile replacement usually doesn’t require a permit; moving plumbing, electrical, or a wall does. On a straight backsplash or floor swap, you’re typically in the clear. If your job touches anything structural or moves a gas or water line, we pull the permit and pass inspection before we close it out.
Yes. A backsplash replacement on existing cabinets is a standard job, and we work around the existing plumbing and electrical rather than moving them. The only thing that changes is outlet cutouts and the edge where the tile meets the counter. If you’re keeping the cabinets, this is the lowest-scope way to update the kitchen.
Full-scope kitchen tile and backsplash runs $14,000 – $45,000; a standalone backsplash runs $800 – $2,500. Floor tile is quoted by square footage and substrate condition, so the number depends on your layout and what’s under the old floor. Call (833) 968-1198 for a written estimate; it’s free and no-pressure.
Every backsplash, tile, and flooring job we do is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space. You get it in writing before we start.
Many Fountainebleau homeowners pair a kitchen tile project with a bathroom refresh; if that’s on your list, our Tub-to-Shower Conversion in Fountainebleau and Vanities, Tile & Fixtures in Fountainebleau pages cover that scope. You can also see our broader Kitchen Remodeling service for the full-picture view, and our Fountainebleau service-area page for what we cover across the ZIP.
Get Your Free Estimate
Call (833) 968-1198 for a free on-site estimate on Backsplash, Tile & Flooring in Fountainebleau. We’ll measure your kitchen, talk through tile and layout options, and leave you with a line-item written quote – no surprises added later. Calls are answered by a live person, 24/7, and the estimate is free whether you hire us or not. No-hassle upfront pricing, and every job is backed by the 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.